R10 Asymmetrical · full lift
RELIABLE · CLEAR FLOOR TWO-POST LIFT
R10 Asymmetrical
Versatile by design. Ready for your shop.
The R10 Asymmetrical combines 10,000 lb of lifting capacity with two installation options: symmetrical or asymmetrical. Choose the traditional centered layout, or angle the columns for a rearward vehicle position and easier passenger-car door access. Three-stage front arms, two-stage rear arms, adjustable screw pads and included four-inch truck adapters give this clear-floor package the reach and height adjustment to handle a varied service lineup.
- Rated capacity
- 10,000 lb
- Front / rear arm stages
- 3 / 2
- Truck adapters
- Included
Clear-floor access. Everyday versatility.
Keep the space between the posts open for transmission jacks, tool carts and the equipment that keeps a job moving. The overhead connection carries the lift structure above the bay, leaving the floor below clear for service work.
Your shop. Your setup.
Equip your bay with the configuration that suits the vehicles you service. The same lift can be installed in either a symmetrical or asymmetrical layout, giving you two installation options without stepping into a different model.
Symmetrical configuration
Facing columns provide a traditional layout with the vehicle positioned more centrally between the posts.
Asymmetrical configuration
Columns angled 30° allow the vehicle to sit farther back, creating more room to open the doors and making entry and exit easier.
Select your configuration during installation. Each layout has different width and clearance dimensions, listed in the specifications below.
Three-stage front arms
Extend your working reach with three-stage front arms and two-stage rear arms. The telescoping sections draw in for closer contact positions and extend when more reach is needed, giving the lift useful range across different vehicles.
Extra height. More room to work.
Four 4 in truck adapters included. These height extensions reach higher vehicle frames and help the lift arms clear running boards and nerf bars. They provide useful clearance for trucks and SUVs while keeping the pads positioned at the vehicle’s approved lifting points. Adjustable screw pads provide fine height adjustment at each contact point.
Also in the package
- 10 anchor bolts and 10 shims
- Two tool trays
- Two toe guards
Drawings & specifications
The published envelope, clearances and maximum arm reach are drawn to a common scale. Hardware outlines and arm angles are representative. Front and arm-reach reference drawings show the symmetrical layout; both installation options appear above.
- Capacity
- 10,000 lb
- Electrical supply
- 220V · single phase
- Time to full rise
- 50 sec
- Safety-lock release
- Single Point Release
- Concrete requirement
- 6" thick at 3500 psi reinforced with fiberglass or steel (4" thick for vehicles 9000LB and below)
- Arm stages · front / rear
- 3 / 2
- Arm / column layout
- Symmetrical / asymmetrical columns
- BOverall height
- 141 3/16 in
- EMax. pad height, no adapters
- 75 in
- FMax. pad height, with adapters
- 81 in
- GMinimum pad height
- 4 in
- HFront arm reach
- 22 7/8 in–42 5/8 in
- IRear arm reach
- 33 5/8 in–52 7/8 in
- AOverall width
- Symmetrical: 139 1/8 in; Asymmetrical: 140 15/32 in
- CDrive-through clearance
- Symmetrical: 104 in; Asymmetrical: 97 in
- Inside-column spacing
- Symmetrical: 113 in; Asymmetrical: 107 in
Downloads
Useful links
Put Reliable to work.
Explore the complete two-post lineup.